Skip to content

Become a RIPE Atlas Probe Host ​

Hosting a RIPE Atlas probe is easy. Create a RIPE NCC Access account and apply for a probe - we'll evaluate your request to determine whether the RIPE Atlas network would benefit from hosting a probe, depending on your location, and let you know if your application has been approved. If your application is approved, we'll send you a probe. Then you just need to register it online and plug it in. Your probe will automatically start performing measurements and you'll start earning credits you can use to perform your own customised measurements.

If you don't want to wait for a hardware probe, you can also install a software probe on your own Linux machine and register it straight away.

1. Create a RIPE NCC Access account ​

If you don't already have a RIPE NCC Access account, please create one. By doing so, you'll become a member of the RIPE Atlas community and will be able to apply for a probe.

*If you are a RIPE NCC member, please make sure you log in to your RIPE NCC Access account using your membership account details before applying for your probe.

2. Apply for a probe ​

WARNING

We are not currently accepting applications for hardware probes. Instead, please install a software probe. It provides the same measurement capabilities as a hardware probe and runs on your own hardware.

You can apply online for your own RIPE Atlas probe. We'll evaluate your request and, if it is approved, we'll send you a probe by post at no charge. Note that there are RIPE Atlas Service Terms and Conditions for hosting a probe.

If you've already received a RIPE Atlas probe from a RIPE Atlas ambassador or sponsor, skip ahead to Step 3 below.

3. Register your probe ​

Once you receive your probe, you'll need to register your probe so we can keep track of it within the RIPE Atlas infrastructure. You need to be logged in to do this.

On the Register Your RIPE Atlas Probe page:

  1. Enter the Probe ID and the MAC Address. You can find both on the probe itself.
  2. Optionally, enter a Description. Click Legal Notice to see what you shouldn't use in a description (for example personal details or other people's trademarks).
  3. Optionally, set the probe's location: click anywhere on the map to drop a pin, or search for an address. You can drag the pin to fine-tune the exact location.
  4. Accept the RIPE Atlas Service Terms and Conditions and the RIPE NCC Privacy Statement, then click Register your probe.

The probe should appear on your dashboard shortly, and in the Mine tab of the probes page.

4. Plug in the probe ​

Once you've registered your probe, you just need to plug it in.

  • Use a UTP cable to connect your probe to an Ethernet port on your home router, switch, etc.
  • Use a USB power outlet to power the probe. In many cases there's one on your switch/router. You can also use a USB charger to connect the probe to a power supply
  • In most networks, the probe will be able to get an IP address with DHCP and nothing further needs to be done to connect the probe. If you do not have a DHCP server already, you can configure DHCP or configure a static IP address (static configuration is necessary for an IPv6-only network)

That's it! It may take a few minutes for the probe to connect to the RIPE Atlas infrastructure. Once it does, you will see information about your probe when you log in to the RIPE Atlas website.

Software probes ​

A software probe is a software package that works as a RIPE Atlas probe on your own hardware, for example a server, a virtual machine or a Raspberry Pi. It doesn't need an application or a probe in the post:

  1. Log in and click Install a Software Probe on the probes page (or go to atlas.ripe.net/install/swprobe).
  2. Select your platform and run the install commands shown on the page.
  3. Register the probe with the public key that the installer prints.

See RIPE Atlas Software Probes for the full instructions.